Electropermanent Magnetic Chuck Doublemag

These magnetic modules are adhesive on both sides and both clamp the workpiece and themselves to the machine table.

Size [mm]
180 x 180 x 55
Field of application
milling, rotating, drilling
Holding force
appr. 140 N/cm² corresponds to 400kg/Pol
Pole division
Square pole 50 x 50 mm

Price on request

PDF-Download:

Electropermanent Magnetic Chuck Doublemag

* Mandatory fields

Whether while milling (rough and finish machining), drilling, sawing, welding or assembling, the EPM modules or module systems offer a large selection of clamping options, for example, to clamp during edge milling or deburring (without mechanical clamping equipment) or for the simple and quick fastening of workpieces during assembly. Workpieces can be easily and quickly fastened with the Doublemag magnet clamping elements.

Through the use of pole extensions, any unevenness on the workpiece can be compensated for and a deformation of the workpiece can be prevented. Using pole extensions, plane-parallelism of up to 0.01 mm is possible on the workpiece. The processing runs without vibration and an even distribution of holding force is guaranteed throughout the entire ferrous clamping surface. Several Doublemags can be combined to process large parts.

The Doublemag magnet modules have a solid steel surface and are therefore significantly more resistant than conventional plates with epoxy resin against hot chips, coolant and other processing influences.

In the event of a power failure or a cable break of the control line, the workpiece will remain clamped on the Doublemag modules with complete holding force. An accidental loosening of the workpieces through malfunction is also ruled out through the two-button operation both on the controller and on the cable remote control.

 

    Ferrous on both sides

  •     For processing big parts, several Doublemags can be connected with each other and controlled
  •     Drastic reduction of set-up times
  •     A 5-sided processing at simple and fast positioning of the workpiece
  •     Low vibration while milling, and even distribution of holding force over the entire magnetic clamping surface
  •     Using pole extensions, plane-parallelism of up to 0.01 mm is possible on the workpiece
  •     Distortion-free holding of raw part or uneven workpiece, because positive-locking clamping by means of fixed and mobile pole extension
  •     underlining of workpieces no longer necessary
  •     No damage to the magnetic clamping plate if there are breaks on the workpiece
Technical data

Dimensions
[L x B x H]

Number of polesVoltageAmpereWeightItem No.
 [mm] [Volt][A][kg] 
DM 502180 x 180 x 552 x 440021252186